

Sparco 600 Seat Bracket - Subaru Baja (2003-2006) - Passenger/Right
The Sparco 600 Series passenger-side seat base bolts to the factory seat mounts in the 2003-2006 Subaru Baja and gives your seat a flat, rigid platform. It is 3/16" steel with a black wrinkle powder coat, and the top plate is drilled for Sparco sliders. Installation is 100% bolt-in.
| Manufacturer: | 600SB261R |
- Fits 2003-2006 Subaru Baja, passenger/right side
- Sparco-branded top plate drilled for Sparco sliders. Other slider brands may require drilling
- Wide platform for direct side-mount installation (drilling required)
- 3/16" steel, black wrinkle powder coat
- 100% bolt-in to the factory seat mounts
- Sold individually. The driver side is 600SB261L
- Photos show the Sparco top plate and the vehicle-specific mounting base separately (base shown with a Planted top plate)
- Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use
Disclaimers:
- Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
- Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
- Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
- Professional installation is recommended.
A built 2003-2006 Subaru Baja can cover terrain the factory seat was never designed for. Whether it's a trail rig, a prerunner or an overland build, a proper aftermarket seat reduces fatigue and keeps you in place over rough ground. It needs a mount that won't flex or loosen.
Sparco 600 Series seat bases pick up the factory seat mounts on the vehicle's floor and give your seat a flat, rigid mounting surface. Each base is vehicle-specific and a 100% bolt-in installation, so there's no cutting, welding or drilling into the floor.
Construction is 3/16" steel with a black wrinkle powder coat, so the base won't flex under load. The top plate carries the Sparco logo and is drilled for Sparco sliders. For race cars that need the lowest seating position, the wide platform lets you drill for side mounts and bolt them straight to the base.
This is the passenger/right base, sold individually. The driver side is 600SB261L. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.
Choose options





