Sparco 600 Seat Bracket - Jeep Wrangler JK 4-Door (2007-2018, Low/Floor Mount) - Driver/Left

• Fits 2007-2018 Jeep Wrangler JK 4-Door (Low/Floor Mount), driver/left side
• Sparco-branded top plate drilled for Sparco sliders. Other slider brands may require drilling
• Wide platform for direct side-mount installation (drilling required)
• 3/16" steel, black wrinkle powder coat
• 100% bolt-in to the factory seat mounts
• Sold individually. The passenger side is 600SB247R
• Photos show the Sparco top plate and the vehicle-specific mounting base separately (base shown with a Planted top plate)
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

A built 2007-2018 Jeep Wrangler JK 4-Door can cover terrain the factory seat was never designed for. Whether it's a trail rig, a prerunner or an overland build, a proper aftermarket seat reduces fatigue and keeps you in place over rough ground. It needs a mount that won't flex or loosen.

Sparco 600 Series bases are vehicle-specific, bolt to the factory floor mounts and provide a flat, stable platform for an aftermarket seat. It's a 100% bolt-in installation, and it's easy to reverse if the car ever goes back to stock.

The base is made from 3/16" steel for a strong, flex-free mount and finished in black wrinkle powder coat. Its Sparco-branded top plate is drilled for Sparco sliders. A wide steel platform also leaves room to mount side mounts directly to the base when you want the lowest possible seat position (drilling required).

This is the driver/left base, sold individually. The passenger side is 600SB247R. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.