Sparco 600 Seat Bracket - Honda Civic 3-Door Hatchback (2nd Gen, 1980-1983) - Driver/Left

• Fits 1980-1983 Honda Civic 3-Door Hatchback (2nd Gen), driver/left side
• Sparco-branded top plate drilled for Sparco sliders. Other slider brands may require drilling
• Wide platform for direct side-mount installation (drilling required)
• 3/16" steel, black wrinkle powder coat
• 100% bolt-in to the factory seat mounts
• Sold individually. The passenger side is 600SB259R
• Photos show the Sparco top plate and the vehicle-specific mounting base separately (base shown with a Planted top plate)
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

Classic cars like the 1980-1983 Honda Civic 3-Door Hatchback were built long before modern seat design, and the original seats offer little support by today's standards. Whether it's a restomod, a vintage racer or a weekend driver, an aftermarket seat transforms the driving position.

Sparco 600 Series seat bases pick up the factory seat mounts on the vehicle's floor and give your seat a flat, rigid mounting surface. Each base is vehicle-specific and a 100% bolt-in installation, so there's no cutting, welding or drilling into the floor.

Construction is 3/16" steel with a black wrinkle powder coat, so the base won't flex under load. The top plate carries the Sparco logo and is drilled for Sparco sliders. For race cars that need the lowest seating position, the wide platform lets you drill for side mounts and bolt them straight to the base.

This is the driver/left base, sold individually. The passenger side is 600SB259R. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.