Sparco 600 Seat Bracket - Audi RS6 (C5, 2002-2004) - Passenger/Right

• Fits 2002-2004 Audi RS6 (C5), passenger/right side
• Sparco-branded top plate drilled for Sparco sliders. Other slider brands may require drilling
• Wide platform for direct side-mount installation (drilling required)
• 3/16" steel, black wrinkle powder coat
• 100% bolt-in to the factory seat mounts
• Sold individually. The driver side is 600SB212L
• Photos show the Sparco top plate and the vehicle-specific mounting base separately (base shown with a Planted top plate)
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

Whether you're adding a supportive seat for daily driving, an HPDE build or a comfort upgrade, the 2002-2004 Audi RS6 needs a proper mount to carry it. The factory seat tracks won't accept an aftermarket seat, and universal plates rarely sit flat on the floor.

Sparco 600 Series seat bases pick up the factory seat mounts on the vehicle's floor and give your seat a flat, rigid mounting surface. Each base is vehicle-specific and a 100% bolt-in installation, so there's no cutting, welding or drilling into the floor.

It's built from 3/16" steel for stiffness and finished in black wrinkle powder coat. The Sparco top plate is drilled for Sparco sliders. There's also a wide platform for direct side-mount installation (drilling required), which drops the seat as low as possible in a race car.

This is the passenger/right base, sold individually. The driver side is 600SB212L. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.