Coolshirt Water Hose - 4ft

• 4ft length — Coolshirt's standard hose for SXS and other tight-cockpit applications
• Foam-insulated body helps maintain water temperature between cooler and garment
• Two female and two male connectors with upgraded CPC American-made fittings
• Connector components manufactured in 2024 and newer
• Built for repeated connect/disconnect cycles (driver swaps, storage, session breaks)
• Suited to building or rebuilding a Club Cooler System from individual components
• Applications: motorsports and industrial cooling systems

The Coolshirt® 4ft Standard Water Hose is the connection between your Coolshirt cooling unit and your cooling garment, carrying chilled water with minimal heat transfer along the way. Foam insulation wraps the hose body to help maintain water temperature between the cooler and the shirt, so the cooling effect at the garment stays consistent rather than warming up over the run of the hose.
The hose is fitted with two female and two male connectors using upgraded CPC American-made fittings, with components manufactured in 2024 and newer — important to know if you're matching this hose to an older Coolshirt setup, since fitting generations can differ. These connectors are built for repeated connect/disconnect cycles, which matters for driver swaps, off-season storage, or simply unplugging your garment between sessions.
At 4 feet, this is the standard length most commonly used in SXS (side-by-side) and other tight-cockpit applications where the cooler is mounted close to the driver. It's also a practical choice for anyone building or rebuilding a Coolshirt Club System from individual components, replacing a worn or damaged hose, or running a setup where a shorter connection length keeps slack out of the cockpit. Suitable for both motorsports and industrial cooling applications.