Sparco 600 Seat Bracket - Toyota Celica All-Trac GT-Four (1990-1993) - Passenger/Right

• Fits 1990-1993 Toyota Celica All-Trac GT-Four, passenger/right side
• Sparco-branded top plate drilled for Sparco sliders. Other slider brands may require drilling
• Wide platform for direct side-mount installation (drilling required)
• 3/16" steel, black wrinkle powder coat
• 100% bolt-in to the factory seat mounts
• Sold individually. The driver side is 600SB253L
• Photos show the Sparco top plate and the vehicle-specific mounting base separately (base shown with a Planted top plate)
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

The 1990-1993 Toyota Celica All-Trac GT-Four has a loyal following among drivers who use their cars properly, and a real seat is part of almost every serious build. The factory seat tracks were never designed to carry a bucket, and fabricating a mount wastes time and rarely ends up square.

Sparco 600 Series bases are vehicle-specific, bolt to the factory floor mounts and provide a flat, stable platform for an aftermarket seat. It's a 100% bolt-in installation, and it's easy to reverse if the car ever goes back to stock.

The base is made from 3/16" steel for a strong, flex-free mount and finished in black wrinkle powder coat. Its Sparco-branded top plate is drilled for Sparco sliders. A wide steel platform also leaves room to mount side mounts directly to the base when you want the lowest possible seat position (drilling required).

This is the passenger/right base, sold individually. The driver side is 600SB253L. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.