Sparco 600 Seat Bracket - Chevrolet Corvette C6/C7 (2005-2019, Non-ZR1) - Driver/Left

• Fits 2005-2019 Chevrolet Corvette C6/C7 (Non-ZR1), driver/left side
• Sparco-branded top plate drilled for Sparco sliders. Other slider brands may require drilling
• Wide platform for direct side-mount installation (drilling required)
• 3/16" steel, black wrinkle powder coat
• 100% bolt-in to the factory seat mounts
• Seat belt tab on both the inboard and outboard sides
• Sold individually. The passenger side is 600SB250R
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

Owners who take a 2005-2019 Chevrolet Corvette C6/C7 to the track quickly find the limit of the factory seat's support. Moving to a fixed-back bucket makes the car easier to drive at pace, but the cockpit is tight and the floor isn't flat, so the mounting solution has to be right the first time.

Sparco 600 Series seat bases pick up the factory seat mounts on the vehicle's floor and give your seat a flat, rigid mounting surface. Each base is vehicle-specific and a 100% bolt-in installation, so there's no cutting, welding or drilling into the floor.

The base is made from 3/16" steel for a strong, flex-free mount and finished in black wrinkle powder coat. Its Sparco-branded top plate is drilled for Sparco sliders. A wide steel platform also leaves room to mount side mounts directly to the base when you want the lowest possible seat position (drilling required).

Seat belt tab on both the inboard and outboard sides.

This is the driver/left base, sold individually. The passenger side is 600SB250R. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.