Sparco 600 Seat Bracket - Chevrolet Cobalt (2005-2010) - Passenger/Right

• Fits 2005-2010 Chevrolet Cobalt, passenger/right side
• Sparco-branded top plate drilled for Sparco sliders. Other slider brands may require drilling
• Wide platform for direct side-mount installation (drilling required)
• 3/16" steel, black wrinkle powder coat
• 100% bolt-in to the factory seat mounts
• Fits the 2005-2010 Chevrolet Cobalt coupe & sedan
• Sold individually. The driver side is 600SB225L
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

Autocross, track days or a canyon road, the 2005-2010 Chevrolet Cobalt rewards a driver who stays located in the seat. The factory seat's bolsters and foam give up long before the chassis does. Swapping to an aftermarket bucket is one of the most effective upgrades you can make, provided the mount is as rigid as the seat.

Every Sparco 600 Series base is built for a specific vehicle and bolts straight to the factory seat mounting points. It turns an uneven factory floor into a flat, solid platform for your seat, and the install is fully bolt-in.

It's built from 3/16" steel for stiffness and finished in black wrinkle powder coat. The Sparco top plate is drilled for Sparco sliders. There's also a wide platform for direct side-mount installation (drilling required), which drops the seat as low as possible in a race car.

This is the passenger/right base, sold individually. The driver side is 600SB225L. Confirm your seat's dimensions against the cabin before ordering. Removing the factory seat can trigger airbag or occupancy warning lights, which may need a resistor. Professional installation is recommended.