Planted Seat Bracket - Nissan 350Z 6-Speed (2003-2008, Low Mount) - Passenger/Right

• Fits 2003-2008 Nissan 350Z with 6-speed manual transmission, passenger/right side
• Low mount: seat sits behind the passenger-floor hump, about as low as the low driver bracket
• The hump may limit forward slider adjustment
• Standard bolt pattern: includes the Recaro slider pattern. Cobra Wide and Scheel-Mann sliders need one hole per slider elongated 1/8"
• Laser-cut 3/16" steel, hand-welded in the USA, black powder coat
• Pre-slotted for most major slider patterns, with room for custom drilling
• Not for automatic-transmission 350Z models. Sold individually
• Not an FIA-homologated seat mount. Confirm acceptance with your sanctioning body before competition use.

Disclaimers:

• Seats come in many different shapes and sizes, so not all seats will fit in all vehicles. It is up to the end user to determine if the seat will fit before ordering the seat bracket and other components.
• Many vehicles have the steering wheel offset toward the center of the vehicle. This can be accentuated when installing an aftermarket seat of a different size than the factory seat.
• Replacing a factory seat with an aftermarket seat may cause the vehicle's warning indicators to activate. This can be due to airbag, weight and/or other sensors in the factory seat that are not included in an aftermarket seat. It may be possible to eliminate these indicators with an electronic resistor, but it is up to the end user to determine if a resistor will work and which resistor to use.
• Professional installation is recommended.

The 350Z passenger floor is the awkward one. A large hump runs through it, and the pan differs between automatic and 6-speed cars. Planted's standard 6-speed passenger bracket rides on top of that hump. This low version drops the seat behind it instead, putting the passenger about as low as Planted's low driver bracket without cutting the floor.

There's a trade-off. Because the seat sits further rearward, the hump can limit how far forward the sliders travel. For a passenger or instructor seat that's rarely an issue, and the lower seating position gives much better helmet clearance under the Z's roofline.

Construction matches the rest of Planted's range. It's laser-cut 3/16" steel, hand-welded for full weld penetration, powder-coated black and checked at three quality-control stages. The mounting surface is pre-slotted for Recaro, Sparco, OMP, Cobra, Corbeau, Racetech and other major slider patterns. There's extra material for custom drilling or for a direct side-mount install without sliders.

This bracket is for manual-transmission cars only. Automatic 350Z models use a different passenger bracket. It's sold individually. Check your seat's fitment before ordering, and plan for occupancy sensor warnings once the factory seat is removed. Professional installation is recommended.